Russound K2 - Manual (Page 18)

18
INSTALLER
Programming Port
3
3
SETUP BUTTON – Accesses and clears the programming menu for manually programming the keypad and getting information
PROGRAMMING PORT – Connects to a computer for keypad programming, configuration backup, and firmware updates
IR LEARNING RECEIVER DIODE – Receives signals from a remote control when the keypad is learning IR commands
1
2
1
2
DATA
DATA
GND
Programming Port
The Programming Port is used for programming the SaphIR
K2, backing up the keypad configuration, and updating the
keypad firmware with a Windows-based computer. These pro-
cedures require a Programming Cable, Russound part num-
ber 2500-121036.
Keypad Programming
The SaphIR K2 can be programmed by using Russound’s free
EZpro software on a computer. You can download EZpro from
the Infrared Products page in the Document Center at
www.russound.com.
Configuration Backups
The K2 keypad configuration can be backed up to a comput-
er using either EZpro or Russound’s RNET Backup Utility. The
Backup Utility is available on the RNET Systems page in the
Document Center at www.russound.com.
Firmware Updates
From time to time Russound may issue updated firmware for
the SaphIR K2 keypad, which you can load into it from a com-
puter. Any firmware update files and associated instructions
are available on the Infrared Products page in the Document
Center at www.russound.com.
+12VDC