Russound K2 - Manual (Page 40)

40
SYSTEM MENU
The System Menu contains items that allow you to obtain information about the keypad and perform various utilities.
To enter the System Menu, select SYSTEM from the top level of the Programming Menu and press Play . The menu offers the
following procedures:
KEYPAD ID COPY CONFIG SYS INFO UPDATE FIRMW FACTORY INIT DIAGNOSTICS
Keypad ID Procedure (Conditional)
This procedure allows you to assign a unique ID number to each keypad (up to 16) in a multiple-keypad system. This is necessary
for copying the programming from one keypad to the others using the Copy Configuration Procedure. See System Menu flow
chart on page 53.
To begin the Keypad ID Procedure, select KEYPAD ID from the System Menu and press Play .
1. Select and enter a unique number for the keypad.
Copy Configuration Procedure (Optional)
This procedure allows you to copy the configuration from a programmed keypad to other keypads, either all at once or one by one.
Note: You must complete the Keypad ID Procedure for all keypads before you perform the Copy Configuration Procedure. The key-
pads have to be installed and wired, and the IR signal line must be common before performing this procedure. See System Menu
flow chart on page 53.
To begin the Copy Configuration Procedure, select COPY CONFIG from the System Menu and press Play .
1. COPY TO... – Select and enter ALL KEYPADS or a single keypad ID.
2. ARE YOU SURE? – Select and enter Yes to start copying or No to cancel the procedure.
INSTALLER
Programming Menu Instructions