Russound K2 - Manual (Page 7)

7
POWER KEY – Turns the keypad on and off while in System mode. Press and
hold for All On or All Off function.
SYSTEM MODE KEY – Selects System mode to control the SaphIR K2 keypad
and connected sources. The remote must be in System mode to work
with the SaphIR K2 keypad.
NUMERIC KEYS – For direct selection of channels or tracks.
VOLUME UP/DOWN KEY – Raises and lowers the amp/receiver volume.
COMMAND KEYS – Control the source equipment.
DIRECT SOURCE SELECT KEYS – Directly select sources 1– 8 controlled by
the keypad while in System mode.
F1 AND F2 KEYS – Set and select Favorite 1 and Favorite 2 presets.
CURSOR KEYS – Issue navigation commands for source equipment, allowing
movement through menus and program screens.
INPUT KEY – Scrolls through sources controlled by the keypad while in
System mode. Works the same as the keypad’s Source key.
LOCAL DEVICE CONTROL KEYS – Select local device modes for direct con-
trol of the devices. These keys change the SRC2’s operating layer.
SETUP KEY – For programming the remote’s local device control keys using
the built-in library or learning capability.
USER
Optional SRC2 Advanced Learning Remote Control
The optional SRC2 remote control will operate the K2 keypad and all sources
the keypad is programmed to control without having to program the remote.
The SRC2 may be programmed to control three additional local devices.
1
2
3
4
5
6
7
8
9
11
10
1
2
3
4
5
6
7
8
9
11
10