Roland Audio Processor SL-20 - Manual (Page 16)

16
Operating the SL-20
Setting the Tempo Response When Slice
Patterns Are Switched
When switching slice patterns, you can have all the patterns play at a set tempo,
without the tempos switching to the ones set in each individual pattern.
1. While holding down the PEDAL MODE button, turn on the power to the SL-20.
The upper part of the TEMPO indicator lights in green.
* Plugging into the INPUT R/MONO jack switches on the power.
2. When the TEMPO indicator starts flashing, release the PEDAL MODE button.
3. Use the PATTERN knob to select the method used for setting the slice patterns.
4. Press the PEDAL MODE button.
The TEMPO indicator flashes three times, and the setting is saved to the SL-20’s
internal memory.
Once the setting is saved, and the SL-20 returns to its normal operating status.
* Be sure not to turn off the power while the TEMPO indicator is flashing.
* This setting remains stored even after the power is turned off.
* The factory default setting for this action is PATTERN 1.
PATTERN Explanation
1
Each time the slice patterns are switched, the tempo changes to that
of the pattern you are switching to.
When the slice pattern is switched, playback of the new pattern be-
gins immediately.
2
The tempo does not switch when the slice patterns are switched.
When a new slice pattern is selected, the current slice pattern plays
to its end, after which the new slice pattern starts playing.
SL-20_e.book 16 ページ ２００８年３月２８日 金曜日 午前８時２８分