Roland Audio Processor SL-20 - Manual (Page 5)

5
Panel Descriptions
Rear Panel
INPUT Jacks (INPUT R/MONO, L)
These input jacks are used for connecting
electric guitars, bass guitars, other
instruments, and effects processors.
If using monaural input, connect only to the
R/MONO jack.
“Making the Connections” (p. 7)
* The INPUT R/MONO jack also doubles as
the power switch. The power comes on when
a plug is inserted into the INPUT R/MONO
jack, and goes off when it is unplugged.
Unplug any connected plugs when the unit
is not in use.
EXP Pedal Jack
Connect an optional expression pedal (such as the
Roland EV-5; optional) to this jack.
Once connected, the pedal can be used to control the
direct level and effect level in real time.
* Use only the specified expression pedal (such as the
Roland EV-5; optional). By connecting any other
expression pedals, you risk causing malfunction and/or
damage to the unit.
“Controlling Functions with an Expression
Pedal” (p. 15)
DC IN (AC Adaptor) Jack
This jack is for connecting an AC
adaptor (BOSS PSA series;
optional).
Using an AC adaptor allows for
long performances without
worrying about the batteries
going dead.
* When you are using an AC
adaptor, be sure to use only the
specified type (PSA series;
optional). Using an adaptor
other than the specified type may
cause the unit to malfunction, or
cause damage to the unit.
MIDI IN Connector
This connector receives the MIDI clock from
a connected external MIDI device to
synchronize the devices’ tempos.
“Synchronizing Performances with
External MIDI Devices” (p. 18)
OUTPUT Jacks (OUTPUT R/MONO, L)
Use these jacks to connect the SL-20 to a guitar amp,
a keyboard amp, or to an effects processor, mixer,
multitrack recorder, or other such device.
Connecting to both the R/MONO and L jacks
allows you to achieve a variety of stereo effects.
If using monaural output, connect only to the R/
MONO jack.
“OUTPUT MODE Button” (p. 3)
“Making the Connections” (p. 7)
“Setting the Output Mode” (p. 17)
SL-20_e.book 5 ページ ２００８年３月２８日 金曜日 午前８時２８分