Roland Audio Processor SL-20 - Manual (Page 17)

17
Operating the SL-20
Setting the Output Mode
You can have the output mode stereo effect (p. 3) applied to the direct sound when the
effect is switched on.
1. While holding down the PEDAL MODE button, turn on the power to the SL-20.
The upper part of the TEMPO indicator lights in green.
* Plugging into the INPUT R/MONO jack switches on the power.
2. When the TEMPO indicator starts flashing, release the PEDAL MODE button.
3. Use the PATTERN knob to set the output mode.
4. Press the PEDAL MODE button.
The TEMPO indicator flashes three times, and the setting is saved to the SL-20’s
internal memory.
Once the setting is saved, and the SL-20 returns to its normal operating status.
* Be sure not to turn off the power while the TEMPO indicator is flashing.
* This setting remains stored even after the power is turned off.
* The factory default setting for this action is PATTERN 3.
PATTERN Explanation
3 The stereo effect is applied to the direct sound.
4 The stereo effect is not applied to the direct sound.
SL-20_e.book 17 ページ ２００８年３月２８日 金曜日 午前８時２８分