Roland SJ-645EX - Manual (Page 38)

36 Chapter 2: Basic Operation
2-2 Loading Media
Loading Roll Media
1 Open the front cover.
2 Line up with the core diameter of the loaded roll media and refit the left- and right-hand media flanges.
3 Fit the hole on the left side of the roll media all the way onto the left-hand media flange.
Be sure to install the media guide when loading roll media.
Otherwise the roll may fall and cause injury.
Load roll media at the proper position.
Otherwise the roll may fall, resulting in injury.
When the reinforcement pipe is inserted into the paper tube, do not angle the roll media.
The reinforcement pipe may protrude from the roll media and cause injury.
1) 2)
3) 4)
2 in. 3 in.
Line up the ridges
and grooves.
Flange retaining pin
Media flange
Media flange
Do not touch the rail or the inner side of the left and right cover. Touching
the area shown may cause the fingers to be soiled by grease or ink, and may
result in diminished image quality.
Do not put hands inside
Rail portion