Roland SJ-645EX - Manual (Page 39)

37 Chapter 2: Basic Operation
4 Fit the right-hand media flange all the way into the hole on the right-hand side of the roll media, and
tighten the retainer screw to secure in place.
5 Move the media clamps to the two ends of the
platen.
6 Pass the end of the media from the back of the
machine to the front.
Pull out the media until the sensor is hidden
from view.
When roll media sag severely, use the reinforcement pipe inserted
into the roll media. After use, remove the reinforcement pipe from
the paper tube.
Roll media Media flange
(right)
3 in.
Media flange
2 in. Reinforcement pipe
Roll media
2-2 Loading Media
Media clamp Media clamp
Media
Front
Sensor