Ricoh feeder - Manual (Page 19)

When You Have Problems Operating the Machine
13
1
Note
❒ If you cannot make copies as you want because of paper type, paper size, or
paper capacity problems, use recommended paper. See “Copy Paper”, About
This Machine.
❒ Using curled paper often causes misfeeds, soiled paper edges, or slipped po-
sitions while performing staple or stack printing. When using curled paper,
take the stiffness out of the paper with your hands to straighten out the curl,
or load the paper up side down. Also, to prevent paper from curling, lay pa-
per on a flat surface, and do not lean it against the wall.
You want to check print
quality before making a
large print run. You can print a single
copy without specifying
the setting again. Check print quality by printing out
only the first set using the {Sample
Copy}
key.
“ Original is being
scanned by another
function. Please
wait. ” appears.
Copier or Scanner func-
tion is in use. To cancel a job in progress, first press
[Exit]
, and then press the {Copy} key or
{Scanner} key. Next, press the {Stop}
key. When the message “
The Stop
key was pressed. Stop copy-
ing? ” press [Stop].
“ Cannot display
preview of this
page. ” appears, and
you can not check the
thumb nail image.
The image data may have
been corrupted. Pressing [Exit] displays the preview
screen without a thumbnail.
Problem Cause Solution