Roland FP-2 - Manual (Page 10)

10
Before You Play
Turning the Power On and Off
* Once the connections have been completed (p. 8), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
■ Turning On the Power
1. Before you switch on the power, turn the volume
down all the way by rotating the [Volume] knob.
fig.00-05
2. Press the [Power] switch on the back of the unit.
The power will turn on, and “FP2” appears in the
display.
After a few seconds, the unit becomes operable and
playing the keyboard produces sound.
fig.00-06
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
3. Adjust the volume to obtain the proper volume
level.
■ Turning Off the Power
1. Before switching the power off, turn the volume
all the way down by rotating the [Volume] knob.
fig.00-05
2. Press the [Power] switch on the back of the unit.
The power is switched off.
fig.00-07
Adjusting the Sound’s
Volume and Brilliance
fig.00-08
1. Use the [Volume] knob to adjust the overall
volume level.
Rotating the knob clockwise increases the volume;
counterclockwise rotation decreases it.
Connecting Headphones
Connecting headphones allows you to enjoy playing
anytime, even at night, without concern.
* Headphones are not included. Consult your Roland dealer if
you want to purchase.
fig.00-09
1. Plug the headphones into the Phones jack at the
rear of the piano.
Use the [Volume] knob on the FP-2 to adjust the volume
of the headphones.
* Make sure to use stereo headphones.
* Make sure to use only Roland headphones. Headphones from
other manufacturers may be unable to provide sufficient
volume.
Some Notes on Using Headphones
• To prevent damage to the cord, handle the headphones
only by the headset or the plug.
• The headphones may be damaged if the volume is too
high when they are plugged in. Lower the volume on the
FP-2 before plugging in the headphones.
• To prevent possible auditory damage, loss of hearing, or
damage to the headphones, the headphones should not
be used at an excessively high volume. Use the
headphones at a moderate volume level.
Rear Panel
ON
Lower Position
Rear Panel
ON
Upper Position
FP-2_e.book 10 ページ ２００４年１１月２６日 金曜日 午後４時２５分