RCA UND RECEIVER RTD250 - Manual (Page 23)

DVD Player
20
Slow motion playback
1. Press PLAY/PAUSE on the main unit or PAUSE on the
remote control to freeze the picture during playback.
2. Advance picture in slow motion. Press FORWARD on
the remote control for forward slow motion and REVERSE
(DVD only) for reverse slow motion
Press repeatedly to change speed to 1/16 times, 1/8 times,
1/4 times and 1/2 times.
3. Press PLAY/PAUSE on the main unit or PLAY on the
remote control to resume normal playback.
Progressive scan
1. Make sure the component output is connected to a TV
which accepts progressive scan signal. To enable progres-
sive scan, press and hold BASS / TRE for 3 seconds in STOP
mode.
2. Once the progressive scan ON/OFF status is displayed,
press the BASS/TRE key to toggle between ON and OFF.
Wait for 3 seconds: the blue light will be on if the progres-
sive scan function is active.
Note: The progressive Scan function can only be selected
in STOP mode.
On-screen banner display
You can access the on-screen banner display during play-
back to select many playback features. Each feature is illus-
trated with an icon. However, each feature shown in the
banner is available only if the disc was created with that
particular feature.
An invalid icon appears on the screen when you
select an icon that does not function. Also, the icon
is “grayed out” to tell you so.
General use
1. Press INFO-RDS on the remote control during playback
to show the on-screen info banner.
2. Use the LEFT or RIGHT arrows on the remote control to
move the cursor on the banner. the selected feature icon
will be highlighted.
3. Press OK to open the menu corresponding to the select-
ed feature.
DISC SKIP
Title Audio
Subtitles
Camera angles Disc type
Chapter Playmode
Time
indicator
Title icon is being
highlighted in
this example
LAY TEST TONE BASS/TRE
PHONES
PROG.
SCAN
DISC SKIP
BOOKMARK
Bookmark
RTD250-EN DVD 10/30/03 10:17 AM Page 2