RAD Data comm ASM-20 - Manual (Page 26)

Chapter 2 Installation and Setup ASM-20 Installation and Operation Manual
2-2 Setting Internal Jumpers and Switches
2.4 Equipment Needed
ASM-20 is a standalone device designed to be placed on a tabletop or bench. It is
delivered completely assembled. No provisions are made for bolting ASM-20 to
the tabletop.
No special equipment is needed for installing ASM-20.
2.5 Setting Internal Jumpers and Switches
To set the jumpers and switches:
1. Disconnect the power cable.
2. Loosen the screws holding the bottom cover in place.
3. Remove the top cover.
4. Adjust the jumpers as required. See
Table 2-1 .
5. Replace the top cover and tighten the retaining screws.