Rimage 480i - Manual (Page 13)

Set up the Rimage 480i Printer
Set up the Rimage 480i Printer
This section provides the information that you need to set up the Rimage 480i printer.
Prepare the Rimage 480i Printer
Use this procedure to prepare the Rimage 480i printer.
1. Remove the cable access door.
2. Connect the power cord to the AC power
adapter.
3. Connect the AC power adapter to the printer.
4. Connect the power cord to an outlet.
-
Important! Connect the USB cable only when
the software prompts you to connect it. Refer
to the
Install the Rimage Software and Printer
Driver section below.
5. Install the ink cartridges. Refer to the Replace
the Ink Cartridges section on page 23.
PC
480i
Printer
AC Power
Adapter
Power
Cord
USB
Cable
Cable
Access
Door
Install the Rimage Software and Printer Driver
Use this information to install the Rimage software and printer driver.
Install the Rimage Software
1. Power on the PC.
2. Insert the CD Designer software disc in the PC. The Rimage CD Designer Software Suite window opens.
Tip: If the software installation does not start automatically, select Start and then Run. Browse to the
setup.exe file on the disc.
3. Select Next in the Rimage CD Designer Software Suite window. The Setup Type dialog box opens inside
the Software Suite window.
4. Select Rimage 480i Printer in the Setup Type dialog box and choose Next.
5. Follow the onscreen prompts to complete the software installation.

Note: In Windows XP, a Software Installation window may open. Select Continue Anyway to complete
the required software installation.
When the Rimage software installation is complete, the Software Installation window and Rimage CD
Designer Software Suite window close, and the Plug-n-Play Hardware Setup for Printers window opens.
Follow the instructions in the
Install the Printer Driver section on page 10 to continue.
110761_D 9