Rimage 480i - Manual (Page 14)

Rimage® 480i Printer User Guide
Install the Printer Driver
You must install the printer driver before you can use the Rimage 480i printer with any label editing software.
1. Follow the onscreen instructions in the Plug-n-Play window to install the printer driver.
-
Important! Do not select the Next button until you follow all of the steps that are listed at the top of the
Plug-n-Play window.
y If you use Windows 2000, the printer driver is automatically installed.
y
If you use Windows XP, the new hardware is detected and the Found New Hardware Wizard dialog box
opens. Answer all of the questions in this dialog box before you continue with the printer driver
installation.

Note: In Windows XP, a Hardware Installation window may open. Select Continue Anyway to
proceed with the installation. When the hardware installation is complete, the Hardware Installation
window and the Found New Hardware Wizard dialog box close.
2. When the printer driver installation is complete, select Next on the Plug-n-Play window.
3. Select Finish. The Plug-n-Play window closes and the printer driver installation is complete.
4. Attach the cable access door to the side of the printer so the cables come out of the access door opening.
5. Align the ink cartridges. Refer to the Align the Ink Cartridges section on page 18.
10 110761_D