Radio Shack 15-2107 - Manual (Page 23)

23 Preparation
8. To save the settings, hold down SELECT until
IK9# IK9# IK9# IK9#
9;II 9;II 9;II 9;II
appears.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, then the last-used
screen.
ADJUSTING SOUND
Your remote has three alert beep tones.
Sound is preset to On. Follow these steps to turn sound
off or on.
1. Hold down P for at least 3 seconds.
9E:;ý I;J 9E:;ý I;J 9E:;ý I;J 9E:;ý I;J
appears.
Note: To exit setup, hold down P for at least 3 sec-
onds.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, then the last-used mode
screen.
2. Touch the up arrow.
IEKD: IEKD: IEKD: IEKD:
appears.
Note: If you scroll past
IEKD: IEKD: IEKD: IEKD:
, touch the down arrow
to return to it.
3. Touch SELECT .
ED ED ED ED
or
EEEE<< << << <<
appears.
Note: If you change your mind, touch the up or
down arrows until you see
ED ED ED ED
, then continue with
Step 4.
4. Touch SELECT .
IK99;II IK99;II IK99;II IK99;II
appears, then
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
, then
the last-used mode screen.
SETTING UP THE REMOTE
Note: If no key is pressed for 60 seconds, the remote
control automatically exits setup.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, and
the remote returns to the previous mode screen.
1. Find the codes for your device(s) in “Manufacturers’
Codes” on Page 47. On the supplied label, write
Tone Type of Alert
One low tone Valid key press or touch
One high tone Invalid key press or touch
Double low tone Valid mode key touch