Radio Shack 15-2107 - Manual (Page 27)

27 Preparation
long as it has been set up as a television, VCR, cable
box, or satellite receiver).
Important: If you program Favorite Channel Scan, you
can no longer use
SCAN for Channel Scan (see “Using
Channel Scan” on Page 37). If you want to use the re-
mote for Channel Scan after you have programmed it for
Favorite Channel Scan, you must reset the entire opera-
tion of the remote (see “Using Operation Reset” on
Page 44). You lose all stored information.
Note: If no key is pressed for 60 seconds, the remote
control automatically exits setup.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, and
the remote returns to the previous mode screen.
Follow these steps to program Favorite Channel Scan.
1. Hold down P for at least 3 seconds.
9E:;ý I;J 9E:;ý I;J 9E:;ý I;J 9E:;ý I;J
appears.
Note: To exit setup, hold down P again for at least 3
seconds.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, then the last-used mode
screen.
2. Touch the up arrow twice.
<7Lý9>7D <7Lý9>7D <7Lý9>7D <7Lý9>7D
appears.
Note: If you scroll past
<7Lý 9>7D <7Lý 9>7D <7Lý 9>7D <7Lý 9>7D
, touch the down
arrow to return to it.
3. Touch SELECT . The last selected mode appears.
4. Touch a device key ( TV , VCR/DVD , CAB/SAT , AUX 1 ,
AUX 2 , AUX 3 , or AUX 4 ). The selected mode
appears.
5. Touch SELECT .
;DJý9>7D ;DJý9>7D ;DJý9>7D ;DJý9>7D
appears.
6. Enter a favorite channel by touching the corre-
sponding numbers on the keypad. To accept the
entry, touch
SELECT .
;DJý9>7D ;DJý9>7D ;DJý9>7D ;DJý9>7D
appears.
Note: A channel number can be up to four digits (for
example, 2, 13, 132, or 1024).
7. Repeat Step 6 up to nine more times to enter other
favorite channels for the same device.