Radio Shack 15-2107 - Manual (Page 41)

41 Operation
3. Touch the down arrow two times.
B;7HD B;7HD B;7HD B;7HD
appears.
Note: If you scroll past
B;7HD B;7HD B;7HD B;7HD
, touch the up key to
return to it.
4. Touch SELECT . The last selected mode appears.
5. If needed, touch a mode key to select a different
device to be learned.
6. Place your original device’s remote control head-to-
head (about 2 inches apart) with the 8-In-One.
Note: For best results, use low-level ambient light-
ing and stay away from high levels of natural day-
light or energy-efficient fluorescent lights.
7. On the original remote control, hold down the key
you want to be learned. On the 8-In-One, touch a
key where you want the learned data to reside. The
red light flashes rapidly and
B;7HD?D= B;7HD?D= B;7HD?D= B;7HD?D=
appears.
Note: Be sure to press (or touch) each key within 5
seconds. Otherwise, an error message appears as
a reminder to perform the actions listed in this step.
If
?DL7B?: ?DL7B?: ?DL7B?: ?DL7B?:
appears, the selected key cannot be
learned.
If
IK99;II IK99;II IK99;II IK99;II
appears, the selected key was learned.
If there is a problem,
;HHEH ;HHEH ;HHEH ;HHEH
appears. Repeat Step 6
until
IK99;II IK99;II IK99;II IK99;II
appears.
To learn other functions from the same device’s
remote control, repeat Steps 6 and 7.
8. To exit programming, hold down P for at least 3 sec-
onds.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, then the remote control
returns to the last-used mode screen.
If desired, repeat Steps 2–8 to learn functions from a dif-
ferent device’s remote control.