Radio Shack 15-2107 - Manual (Page 24)

24
Preparation
down the codes for the brand of each device you
want to program.
Note: Some manufacturers may have several
codes listed. Try each until you find the right one. If
you cannot find the correct code, see “Manufacturer
Code Search” on Page 25.
2. Turn on all home entertainment devices.
3. Hold down P for at least 3 seconds.
9E:;ý I;J 9E:;ý I;J 9E:;ý I;J 9E:;ý I;J
appears.
4. Touch SELECT . The last selected mode appears.
Note: To exit this mode at any time, hold down P
again for at least 3 seconds.
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, then
the last-used mode screen.
5. Touch the desired mode key ( TV , VCR/DVD , CAB/
SAT , RECVR , AUX 1 , AUX 2 , AUX 3 , or AUX 4 ). The
default or previously set device and code appear.
6. If the displayed device is not the desired type, use
the up or down arrows to scroll to a device you
want. Then touch
SELECT . The selected device and
its (default or previously set) code appear.
Note: There are 13 different devices available for
setup. Refer to “A Quick Look at the Keys” on
Page 6 for additional information on a desired
device.
7. Using the keypad, enter the first 4-digit manufac-
turer’s code for the desired device and then touch
SELECT . If you’ve entered a correct code,
IK99;II IK99;II IK99;II IK99;II
appears.
If the code is not correct ,
DDDDEJý<EKD: EJý<EKD: EJý<EKD: EJý<EKD:
appears instead.
Enter the next code until
IK99;II IK99;II IK99;II IK99;II
appears.
Note: For TV/VCR combinations, touch VCR/DVD in
Step 4 and use the VCR code listed for your model
under “TV/VCR Combo Codes” on Page 60. If your
TV/VCR combination also lists a TV code, you must
program the TV separately by repeating Steps 4