Raymarine 150/400 - Manual (Page 37)

Step 7: Install the Control Unit 29
St
ep
7
Step 7: Install the Control Unit
Raymarine produce a range of control units to suit different boats and
user requirements.
The ST6001+ and ST7001+ control units have been designed
specifically to provide access to all advanced functions on the
Type 150, 150G, 400 and 400G course computes.
You can also use the following control units to operate the course
computer autopilot system, but they do not enable access to some of
its more advanced functions:
• ST6000+ control unit
• ST7000+ control unit
• ST600R remote control unit
• ST80 autopilot keypad (as part of an ST80 instrument system)
• RayPilot 650 control unit
• ST6000 and ST7000 control units
Connecting to the course computer
If your system only includes a single control unit, connect it to one set
of SeaTalk terminals on the course computer.
Í
For full information about control unit functionality, see page 46.
Í
For full information, refer to the control unit owner’s handbook.
Í If you are connecting more than one control unit or a combination of control
units and SeaTalk instruments/equipment, see page 32 of this handbook.
ST7001+
ST6001+
81173_3.book Page 29 Thursday, June 7, 2001 11:51 AM