Control unit nmea inputs, Seatalk/nmea interface, Connecting several items of nmea equipment – Raymarine 150/400 User Manual
Page 46
38
Type 150/400 Autopilot System: Installation Guide
Ste
p
Connect:
•
the NMEA outputs from the equipment (such as navigators, wind
or speed instruments to the NMEA inputs on the course computer
•
the NMEA outputs on the course computer to the NMEA inputs
on the equipment (such as radar)
Control unit NMEA inputs
You can connect the outputs from a single item of NMEA equipment
to the NMEA inputs on the ST6001+ or ST7001+ control units.
SeaTalk/NMEA interface
The SeaTalk/NMEA interface (part number: E85001) enables you to
connect NMEA equipment to the SeaTalk system. It allows the
non-SeaTalk equipment to transmit and receive information to/from
the SeaTalk system.
The interface converts:
•
NMEA data from the equipment into SeaTalk data
•
SeaTalk data from the SeaTalk system into NMEA data
Connect:
•
the NMEA equipment to the SeaTalk/NMEA interface
•
the SeaTalk/NMEA interface to:
•
one of the course computer SeaTalk terminals
•
or, any other SeaTalk product (using one of the available
interface cables)
Connecting several items of NMEA equipment
If you need to connect several NMEA items to the course computer,
you will need to use an appropriate combination of:
•
course computer NMEA inputs and outputs
•
control unit NMEA inputs
•
SeaTalk/NMEA interface (part number: E85001)
Í
For more information, refer to the control unit owner’s handbook.
Í
For more information about NMEA and SeaTalk received and transmitted,
refer to the handbook supplied with the interface.
81173_3.book Page 38 Thursday, June 7, 2001 11:51 AM