Raymarine 150/400 - Manual (Page 9)

Step 1: Check the Installation Kit 1
Ste
p
1
Step 1: Check the Installation Kit
The first step is to get ready for installation by:
• reading through all installation steps
• obtaining the necessary installation tools
• checking the parts supplied
WARNING: Product installation
This equipment must be installed and operated in accordance
with the instructions contained in this handbook. Failure to do so
could result in poor product performance, personal injury
and/or damage to your boat.
Because correct performance of the boat’s steering is critical for
safety, we STRONGLY RECOMMEND that an Authorized
Raymarine Service Representative fits this product. You will
only receive full warranty benefits if you can show that an
Authorized Raymarine Service Representative has installed or
commissioned this product.
1.1 Read this handbook
To prepare for the system installation, read through the following
information and the rest of this handbook to familiarize yourself with
the autopilot system and how to install it.
The autopilot system – core pack contents
Course computer
The course computer lies at the heart of the autopilot system. It
processes information from the sensors in the system (e.g. rudder
position and compass) so it can steer the boat using the drive unit:
• it contains a microprocessor, electronic circuitry to control the
drive unit and a power amplifier for the drive motor.
• it is the central distribution point for the autopilot system, with
terminals to take power from the boat’s distribution panel and
inputs/outputs for all other autopilot components
• it has inputs/outputs for SeaTalk and NMEA so you can connect it
to Raymarine and other manufacturer’s equipment.
81173_3.book Page 1 Thursday, June 7, 2001 11:51 AM