Control health, Combustion air blockage, Temperature probe fault – Rheem HE80-130LP User Manual

Page 20

Advertising
background image

20

POSSIBLE CAUSE

This indicates that the main
control board has failed one or
more of its internal diagnostic
self-tests.

REMEDY
Press red reset button on the
display board to reset the con-
trol. If this error occurs repeat-
edly, replace the main control
board.

CONTROL HEALTH

Control Health LED Flashing

POSSIBLE CAUSE

1. Combustion air blockage.

2. Blower not operating:

a. Blower wiring
b. Blower motor

3. Defective air switch

4. One of the gas valve wires-

may be disconnected dur-
ing ignition sequence.

5. Poly hose between the

blower and air pressure
switch is blocked or discon-
nected.

REMEDY
1. Check intake and exhaust

piping for obstructions.

2a. Repair wiring.
2b. Replace blower motor.

3. Replace air switch.

4. Check wires to Gas valve.

Reseat wires into harness.

5. Remove or correct block-

age connect hose to blow-
er or air pressure switch.

COMBUSTION AIR BLOCKAGE

Pressure Switch LED Flashing

POSSIBLE CAUSE

1. Temp probe wiring open.
2. Defective probe.
3. No water in tank or tank in

freezing conditions.

4. Water level in tank is too low

- probe in steam.

5. Probe wiring shorted.

REMEDY
1. Repair wiring.
2. Replace probe.
3. Control is recording an “out

of bounds” condition. Turn on
water supply; remove tank
from freezing conditions.

4. Control is recording an “out

of bounds” condition. Fill
tank.

5. Replace probe.

TEMPERATURE PROBE FAULT

Water Temp LED Flashing

NOTE:
If the temperature probe housing fractures and allows water into
the sensor section of the probe, this may affect the temperature
display on the display pnael. If the display is showing highly
inconsistent temperature readings, this is an indication the
temperature probe is defective due to water contamination.
Replace probe.

LINE

K1

COMB
BLOWER

K5

IGNITER
ELEMENT

24

VAC

ECO/VENT

SWITCH

SWITCH

PRESSURE

GAS

VALVE

RLY 1

GAS

VALVE

RLY 2

GAS

VALVE

CONTROL

HEALTH

WATER

TEMPERATURE

K1

K5
K3

K4

K4

K3

CONTROL

ELECTRONICS

LINE

K1

COMB
BLOWER

K5

IGNITER
ELEMENT

24

VAC

ECO/VENT

SWITCH

SWITCH

PRESSURE

GAS

VALVE

RLY 1

GAS

VALVE

RLY 2

GAS

VALVE

CONTROL

HEALTH

WATER

TEMPERATURE

K1

K5
K3

K4

K4

K3

CONTROL

ELECTRONICS

LINE

K1

COMB
BLOWER

K5

IGNITER
ELEMENT

24

VAC

ECO/VENT

SWITCH

SWITCH

PRESSURE

GAS

VALVE

RLY 1

GAS

VALVE

RLY 2

GAS

VALVE

CONTROL

HEALTH

WATER

TEMPERATURE

K1

K5
K3

K4

K4

K3

CONTROL

ELECTRONICS

Advertising
This manual is related to the following products: