Ricoh FAX1400L - Manual (Page 51)

Using Key Operator Settings
39
7
User parameter hints
❖ ❖ ❖ ❖ Changing your machine's default settings
These are the settings your machine assumes immediately after it is turned
on, after clearing the machine, or after you or the power saving reactivates it.
Many of the user parameters determine your machine's default settings.
❖ ❖ ❖ ❖ Clear modes after sending or loading a fax message (Switch 01, Bit 7)
Your machine can either reset itself or keep its settings (for a few minutes) af-
ter it sends a fax message.
❖ ❖ ❖ ❖ Automatic reports
Many types of automatic reports can be switched on or off. See P.17 “Checking
if a Transmission Was Successful”. See P.19 “Printed Reports” for details.
❖ ❖ ❖ ❖ Accepting messages when out of supplies (Switch 05, Bit 0)
This is also called substitute reception. You can accept messages even when
out of toner or paper by storing them in memory. See P.21 “Printing Messages
that Have Been Received into Memory (Substitute Reception)”
08 3, 2: AUTHORIZED RECEPTION
(Can also use function 62)
Bit
3, 2:
X 0: Off
0, 1: Receive messages only
from senders whose OWN
NAME/FAX NUMBERs are
programmed.
1, 1: Receive messages only
from senders whose OWN
NAME/FAX NUMBERs are
not programmed.
10 0: Reverse order Printing
SORT
0: Off
1: On
7: Use dithering halftone (SPD) or standard halftone
(STD)
HALFTONE METHOD
0: STD
1: SPD
13 1, 0: Access to the public telephone line
ACCESS METHOD FOR PSTN LINE
Bit: 1, 0
1, 0: Ground Start
0, 1: Loop Start
1, 1: Flash Start
0, 0: PSTN
SW Bit & Definition Settings
Holsten1AE_Advanced_FM.book Page 39 Wednesday, November 8, 2000 11:24 AM