Roland Edirol R-05 - Manual (Page 4)

5
USING THE UNIT SAFELY
002c ● Do not open (or modify in any way) the unit or
its AC adaptor.
..........................................................................................................
003 ● Do not attempt to repair the unit, or replace parts
within it (except when this manual provides
specific instructions directing you to do so). Refer
all servicing to your retailer, the nearest Roland
Service Center, or an authorized Roland
distributor, as listed on the “Information” page.
..........................................................................................................
004 ● Never install the unit in any of the following
locations.
❍ Subject to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle, near
a heating duct, on top of heat-generating
equipment); or are
❍ Damp (e.g., baths, washrooms, on wet
floors); or are
❍ Exposed to steam or smoke; or are
❍ Subject to salt exposure; or are
❍ Humid; or are
❍ Exposed to rain; or are
❍ Dusty or sandy; or are
❍ Subject to high levels of vibration and shakiness.
..........................................................................................................
007 ● Make sure you always have the unit placed so it
is level and sure to remain stable. Never place it
on stands that could wobble, or on inclined
surfaces.
..........................................................................................................
008b ● Use only the specified AC adaptor, and make
sure the line voltage at the installation matches
the input voltage specified on the AC adaptor’s
body. Other AC adaptors may use a different
polarity, or be designed for a different voltage,
so their use could result in damage,
malfunction, or electric shock.
..........................................................................................................
008e ● Use only the attached power-supply cord. Also,
the supplied power cord must not be used
with any other device.
..........................................................................................................
009 ● Do not excessively twist or bend the power
cord, nor place heavy objects on it. Doing so
can damage the cord, producing severed
elements and short circuits. Damaged cords
are fire and shock hazards!
..........................................................................................................
R-05-e.book 5 ページ ２０１０年２月１９日 金曜日 午後４時５５分