5 syslog, Overview, Messages – RCA 605 User Manual
Page 118: Configuration, Syslog, Chapter 5
108
E-DOC-CTC-20051017-0151 v1.0
Chapter 5
Expert Configuration
5.2.5 Syslog
Overview
The Syslog page consists of two sections:
Messages
This section allows to overview system log and alert messages your SpeedTouch™
generated during operation. System log messages are used to provide a historical
overview of events, errors, and messages generated during SpeedTouch™
operation.
Per message following information is shown:
The system message content (and time of generation)
By default the table is automatically refreshed every 30 seconds and shows all
system log messages.
Click Stop AutoRefresh to stop the automatic refreshing of the table.
The Message buffer view options menu becomes accessible to:
level of syslog messages to show in the table.
level of syslog messages to show in the table.
Change the Refresh rate of the table.
As long as AutoRefresh is disabled you can manually refresh the table by
clicking Refresh.
Click AutoRefresh to apply your changes and to start automatic update of the
table (using the new refresh rate).
Configuration
This section allows you to view/configure remote destinations (syslog servers) to
send (a subset of) the SpeedTouch™ syslog messages for remote monitoring
purposes.
To add a destination:
1
In the Facility box, type the
of your choice.
2
In the Severity box, click the
of your choice.
3
In the Destination box, type a destination (IP address or host name) to send
the messages to.
4
Click Add.