Dhcp relay, Relay config, Relay interfaces – RCA 605 User Manual
Page 168: Chapter 5
158
E-DOC-CTC-20051017-0151 v1.0
Chapter 5
Expert Configuration
DHCP Relay
The DHCP relay tab allows you to add/delete and overview SpeedTouch™ 's DHCP
relay interfaces.
The DHCP relay configuration is split up in two sections:
To add/delete and configure a DHCP relay server on a certain interface
To enable/disable and define the behaviour of the DHCP relay agent per
configured interface.
Relay Config
The Relay Configuration table allows you to add or delete (additional) DHCP relay
agents for a specific interface.
To create a new DHCP relay agent:
1
Click New.
2
In the DHCP relay server box, type the IP address of the DHCP server.
3
In the Interface list, click the appropriate relay interface (click None to indicate
no interface is specified).
4
In the Gateway Address (giaddr) box, type the Gateway IP address to be used
for the giaddr field in relayed DHCP packets.
5
Click Apply.
Relay Interfaces
The Relay Interfaces table allows you to configure interface specific DHCP relay
settings as:
Enable/disable the DHCP relay server
The maximum number of hops allowed for relayed DHCP requests and replies
(as indicated in the DHCP packet)
Defining whether to forward (trusted) or to drop (not trusted) DHCP request
packets when a DHCP relay agent info option is present and the Gateway IP
address field is 0 (as specified in RFC3046).
Define the remote ID (as specified in RFC3046) to allow the DHCP relay agent
to relay DHCP responses to the proper network.