2 routed pppoe, Introduction, Creating a routed pppoe connection entry – RCA 605 User Manual
Page 149: Additional configuration, Routing, Routed pppoe, Chapter 5
139
E-DOC-CTC-20051017-0151 v1.0
Chapter 5
Expert Configuration
5.4.2 Routed PPPoE
Introduction
The Routed PPPoE configuration page allows you to add new Routed PPPoE, or
Routed PPPoE Relay connection entries or to change settings of existing entries.
Creating a Routed
PPPoE connection entry
To add a Routed PPPoE connection entry:
1
Click New.
2
In the Interface box, type a unique interface name (different from the MER
interface name).
3
In the Destination list, click the appropriate Routed Ethernet destination
indicated by the Routed Ethernet interface name
4
Type user name and password for the account at the ISP [optional].
5
If applicable, type a Service name and/or Access Concentrator [optional]
6
Click Apply.
Additional configuration
Once created, per Routed PPPoE connection, additional configuration is possible by
clicking:
Routing
Following fields are available:
Destination:
Controls the networks that can be reached via this particular PPP connection.
Specify the remote host or network in prefix notation. e.g. 172.16.0.0/16.
Label:
Allows you to assign a label to this connection.
These parameters can only be modified when the link is down. Take the link
down first by clicking Hang-up.