2 upnp™ on windows xp systems, Adding upnp, Upnp™ on windows xp systems – RCA 605 User Manual
Page 202: Upnp™ (see, Speedtouch™ not detected by upnp™ or igd control, Chapter 7
192
E-DOC-CTC-20051017-0151 v1.0
Chapter 7
Troubleshooting
7.2 UPnP™ on Windows XP Systems
SpeedTouch™ not
detected by UPnP™ or
IGD Control Client
Check the following:
Make sure the UPnP™ and Internet Gateway Device Control Client Networking
components are added to your Windows XP system.
Your computer doesn’t support UPnP™ if you run an operating system other
than Windows XP and Windows Millennium.
Make sure that UPnP™ is not disabled in the SpeedTouch™ Web page; see
“4.5.2 Game & Application Sharing” on page 59
.
Adding UPnP™
If you are running Microsoft Windows XP, it is recommended to add the UPnP™
component to your system.
Proceed as follows:
1
In the Start menu, click (Settings >) Control Panel.
The Control Panel window appears.
2
Click Add or Remove Programs.
The Add or Remove Programs window appears.
3
Click Add/Remove Windows Components.
4
In the Windows Components Wizard, select Networking Services in the
Components list and click Details.
5
In the Networking Services window, select Universal Plug and Play or UPnP
User Interface and click OK.
6
Click Next to start the installation and follow the instructions in the Windows
Components Wizard.
7
At the end of the procedure the wizard informs you that the installation was
successful. Click Finish to quit.