Raritan Computer Raritan ASMI G4 - Manual (Page 18)

Chapter 4. ASMI G4 Module Configuration
Initial Configuration
The ASMI module’s communication interfaces are all based on TCP/IP. It comes pre-configured with the
IP configuration listed in
Table 4-1 . Additionally you can do some simple configuration using the serial
interface.
Table 4-1. Initial network configuration
Parameter Value
IP auto configuration DHCP
IP address -
Netmask -
Gateway -
Warning
If the DHCP connection fails on boot up, the ASMI module will not have obtained
an IP address. This means it will not be accessible over the network.
If this initial configuration does not meet your requirements, this chapter describes the initial IP
configuration that is necessary to access the ASMI module for the first time.
Using the Psetup Tool
The psetup tool is used to determine the IP address assigned to the ASMI by the DHCP server or to
change the device’s initial network configuration. It allows you to access the ASMI module even when it
has no configured IP address.
Psetup can access the ASMI module in two ways:
Locally
Psetup can be invoked directly on the host containing the ASMI module. The psetup tool uses USB
to connect to the module.
Remotely
Psetup can be invoked on any host connected to the same subnet (broadcast domain) as the ASMI
module. Psetup uses UDP broadcasts to find the module.
9