Raymarine Ray215e - Manual (Page 55)

3-32 Operation with Minimum Function Handset
ROTATE
CH
PRESS & REL
DSC
PRESS & REL
DSC
PRESS & HOLD
DSC
ATIS digit digit position
Select desired digit Next digit position Select desired digit
Continue thru last digit position Radio replays all digits...
ATIS number accepted
PRESS & REL
DSC
Returns to working channel
...through the 9th position
Returns to first digit position
ROTATE
CH
Select desired digit
ROTATE
CH PRESS & REL
DSC
PRESS & HOLD
DSC + D/L PRESS & REL
MON
Note: Ensure the ATIS ID number entered is correct with the
verification playback. Once the number is accepted as outlined in the
next step, it can not be changed except by Raymarine representatives.
8. If the number is verified as correct, press and hold the DSC key for 2
seconds and a tone sounds. Your ATIS ID number has now been stored
in memory.
9. If the number is incorrect, press the DSC key once and release. The
radio will revert to the beginning of the entry precess start over again.
This step can be repeated as many times as required until the number
is entered correctly.
After the ATIS ID number has been programmed, the ATIS function will
be active all the time, unless you have a Full Function Handset installed.
With a Full Function Handset, the radio is upgraded to full Class “D”
DSC and, by law, the ATIS function may be toggled on and off. If a Full
Function Handset is installed, you can toggle the ATIS operation on and
off by pressing the SCAN and D/L/I.C keys simultaneously.