Raymarine Ray215e - Manual (Page 74)

4-19 Operation with Full Function Handset
3. Press PTT to speak to the other station and release PTT to listen.
4. To exit Intercom mode, again press FUNC followed by 0/IC.
Receiving a Call at the Base Station
1. When an Intercom call is received, the base station speaker emits a
calling tone. IC appears on the large channel display and REMOTE
flashes on the small channel display.
2. To answer the call, press PTT. The calling tone ceases and REMOTE
stops flashing and appears solid.
Note: If not answered within 60 seconds after being called, the call
terminates and the display returns to its previous state.
3. Press PTT to speak to the other station and release PTT to listen.
4. To exit Intercom mode, again press and hold the D/L/I.C. key.
4.6.15 Scan Mode
During Scan mode, the RAY215E searches through the channels (including
Private Channels), stops when radio traffic is detected, then resumes
scanning after the traffic ceases. Two scan functions are available: All
Channel Scan and Memory Channel Scan. The All Channel Scan function
searches all channels within the same frequency group. The Memory
Channel Scan searches only the channels stored in memory in the same
group.
The scan begins from the channel following the one currently indicated.
The scan is suspended when a carrier is detected. Five seconds after the
carrier ceases, the scan resumes with the next channel. If the carrier is
detected again before 5 seconds elapse, the timer is re-initialized. Press
the 2/SCAN key to resume the scan from the next channel. Pressing FUNC
followed by 2/SCAN key or pressing the CLR key during the scan cancels
the scan.
Upon reaching Channel 88, the radio scrolls back to Channel 1 and
continues the scan. (If Private Channels have been enabled, they are
scanned following Channel 88.) If the scan stops on a channel with traffic
and you wish to communicate with the other party, press the PTT key to
cancel the scan and remain on that channel.
Note: Scan modes are disabled when the ATIS operation is active.
Entering a Channel into Memory:
Follow these steps to enter a channel into memory so it can be monitored
during memory scan.