Raymarine Ray215e - Manual (Page 75)

4-20 Operation with Full Function Handset
1. Use the Channel Selection (CH) keys or numeric keypad to select the
Working Channel or Private Channel you wish to enter into memory.
2. Press the FUNC key followed by the 1/MEM key. The MEM indicator
illuminates, indicating that the channel is now in memory.
Using Memory Scan
This function is available only when at least one channel has been stored
in memory.
Press the FUNC key followed by the 2/SCAN key. The messages MEM
and SCAN flash for 3 seconds on the LCD. A scan of only the channels in
memory is initiated when the 3 seconds elapse or when you press the
ENT key before the 3 seconds elapse.
Pressing FUNC followed by 2/SCAN key or pressing the CLR key during
the scan cancels Memory Scan.
Using All Scan
Press the FUNC key followed by the 2/SCAN key The messages MEM
and SCAN flash for 3 seconds on the LCD. Before the 3 seconds elapse,
press the 2/SCAN key again to begin All Scan. If the 3 seconds elapse
before you press the 2/SCAN key, the radio will enter Memory Scan.
Pressing FUNC followed by 2/SCAN key or pressing the CLR key during
the scan cancels All Scan.
4.6.16 Monitor Mode
Monitor operation can be implemented in one of two modes: Dual-Watch
or Tri-Watch.
Note: Monitor modes are disabled when the ATIS operation is active.
Dual-Watch
In Dual-Watch Mode, the RAY215E operates on the Working Channel or
Private Channel while constantly monitoring the Priority Channel 16. The
radio locks onto the Priority, Working, or Private Channel whenever it
becomes active, then returns to Dual-Watch when there is no activity.
To start Dual-Watch Mode, select the desired Working Channel or Private
Channel, and then press the MON key. The Working Channel or Private
Channel is displayed on the 7-segment display and the Priority Channel
appears on the right side of the dot matrix display.
To end Dual-Watch mode at the current channel, press the MON key or
the CLR key.