Raritan Computer Home Security System - Manual (Page 233)

Chapter 15: Advanced Administration
215
What is IP Isolation mode?
IP Isolation mode allows you to isolate clients from devices by placing
them on separate sub-networks and forcing clients to access the devices
through CC-SG. In this mode, CC-SG manages traffic between the two
separate IP domains. IP Isolation mode does not offer failover. If either
LAN connection fails, users will not have access.
See About CC-SG LAN Ports (on page 211) for the locations of the
Primary LAN and Secondary LAN ports on each CC-SG model.
Note: Clustering cannot be configured when using IP Isolation mode.
Setup for IP Isolation mode:
When implementing IP Isolation mode for your CC-SG network:
•
Each CC-SG LAN port must be connected to a different sub-network.
• Raritan devices must be connected to the Primary LAN only.
•
Clients to be isolated are connected to the Secondary LAN. Clients
that don’t need to be isolated may be connected to the Primary LAN.
See
Configure a Combination of Direct Mode and Proxy Mode
(on page 220).
Note: Isolated clients on the Secondary LAN will use Proxy mode.
The clients on the Primary LAN may use Direct mode. Set the
connection mode to "Both" to configure this combination.