Raritan Computer Home Security System - Manual (Page 92)

Chapter 7: Managed Powerstrips
74
Configuring Powerstrips Connected to SX 3.1
You can perform the following tasks in CC-SG to configure and manage
Powerstrips connected to SX 3.1 devices.
• Add a Powerstrip Connected to an SX 3.1 Device
(on page 74)
• Move an SX 3.1's Powerstrip to a Different Port (on page 75)
• Delete a Powerstrip Connected to an SX 3.1 Device (on page 75)
Add a Powerstrip Connected to an SX 3.1 Device
The procedure for adding a powerstrip connected to an SX 3.1 device
varies, based on whether the SX 3.1 device has been added to CC-SG.
If the PowerStrip is connected to the SX 3.1 device and the device has not
yet been added to CC-SG:
1. Add the SX 3.1 device to CC-SG. See Add a KVM or Serial Device
(on page 34).
2. CCSG detects the PowerStrip and adds it automatically. The
PowerStrip will appear in the Devices tab beneath the SX 3.1 device
to which it is connected.
If the SX 3.1 device has already been added to CC-SG and the PowerStrip is
connected to the device later:
1. Add the SX 3.1 device to CC-SG. See Add a KVM or Serial Device
(on page 34).
2. Configure the ports of the SX 3.1 device. See Configuring Ports (on
page 39).
3. In the Devices tab, select the SX 3.1 device to which the PowerStrip
is connected.
4. Click the + next to the device icon to expand the list of ports.
5. Right-click the SX 3.1 port to which the PowerStrip is connected, and
select Add Powerstrip from the pop-up menu.
6. Enter the number of outlets that the PowerStrip contains, and then
click OK.
Next Steps:
1. Configure outlets. See Configuring Outlets on a PowerStrip (on
page 75).
2. Associate each outlet with the node that it powers. See Interfaces
for Managed Powerstrip Connections (on page 104).