Raritan Computer Home Security System - Manual (Page 307)

Chapter 16: Diagnostic Console
289
Option Description
Diagnostic Console Reset This option restores Diagnostic Console settings back to factory defaults.
IP Access Control Lists
Reset This option removes all entries from the IP-ACL table.
IP-ACL settings are reset with a Full Database reset whether you select
the IP Access Control Lists reset option or not.
See Access Control List (on page 244).
To reset CC-SG to the factory configuration:
1. Choose Operation > Admin > Factory Reset.
2. Select the reset options.
3. Click Reset System.
4. You see a warning message and a progress bar on the screen. The
progress bar indicates the current reset status, and you cannot
control CC-SG before reset is complete.
Do NOT power off, power cycle, or interrupt CC-SG when reset is in
progress. Doing this may result in the loss of CC-SG data.
Diagnostic Console Password Settings
This option provides the ability to configure the strength of passwords
(status and admin) and allows you to configure password attributes, such
as setting maximum number of days that must lapse before you need to
change the password, which should be done via the Account
Configuration menu. The operation in these menus applies only to
Diagnostic Console accounts (status and admin) and passwords; it has
no effect on the regular CC-SG GUI accounts or passwords.
To configure Diagnostic Console passwords:
1. Choose Operation > Admin > DiagCon Passwords > Password
Configuration.