Omega CNiS8DV - Manual (Page 16)

2.3.5 Wiring Outputs (continued)
This meter is capable of supplying 5 or 10 Vdc sensor excitation. The excitation
output connection and location of S2 pin selection jumper are shown below.
Excitation is not available if Serial Communication (-C24) or Ethernet
(-C4EI) or Low Voltage Power Supply (-DC) options are installed.
Figure 2.14
a) Excitation Output b) Top View Location of S2
c) Top View Location of S2 on 1 /
8
DIN Compact Unit
Install jumpers according to the table below.
Table 2.4 Jumper Connections
Excitation Output S2
A B
10 V Close Open
5 V Open Close
Factory default is 10 V.
12