Omega CNiS8DV - Manual (Page 64)

60
Cycle Time
1 to 199 seconds; set to 0 for on/off
operation
Gain
0.5 to 100% of span; Setpoints 1 or 2
Damping
0000 to 0008
Soak
00.00 to 99.59 (HH:MM), or off
Ramp to Setpoint
00.00 to 99.59 (HH:MM), or off
Auto Tune
Operator initiated from front panel
CONTROL OUTPUT 1 & 2
Relay
250 Vac or 30 Vdc @ 3 A
(Resistive Load); configurable for
on/off, PID and Ramp and Soak
Output 1: SPDT type, can be
configured as Alarm 1 output
Output 2: SPDT type, can be
configured as Alarm 2 output
SSR
20-265 Vac @ 0.05-0.5 A
(Resistive Load); continuous
DC Pulse
Non-Isolated; 10 Vdc @ 20 mA
Analog Output (Output 1 only)
Non-Isolated, Proportional 0 to 10 Vdc
or 0 to 20 mA; 500 Ω max
NETWORK AND COMMUNICATIONS
(Optional -C24, -C4EI, -EI not
available with excitation)
Ethernet: Standards Compliance
IEEE 802.3 10Base-T
Supported Protocols: TCP/IP, ARP,
HTTPGET
RS-232/RS-422/RS-485/MODBUS:
Selectable from menu; both ASCII and
modbus protocol selectable from
menu. Programmable 300 to 19.2 K
baud; complete programmable setup
capability; program to transmit current
display, alarm status, min/max, actual
measured input value and status.
RS-485
Addressable from 0 to 199
Connection
Screw terminals
ALARM 1 & 2 (programmable):
Same as Output 1 & 2
Operation
High/low, above/below, band,
latch/unlatch, normally open/normally
closed and process/deviation;
front panel configurations
ANALOG OUTPUT (programmable)
Non-Isolated, Retransmission 0 to
10 Vdc or 0 to 20 mA, 500 Ω max
(Output 1 only). Accuracy is +1% of
FS, for Scaling Gain from 0.03 to
100 mV per count
EXCITATION
(optional in place of Communication)
5 Vdc @ 40 mA
10 Vdc @ 60 mA
Not available for Low Power Option
INSULATION
Power to Input/Output, (Reinforce)
2300 Vac per 1 min. test
1500 Vac per 1 min. test,
(Low Voltage/Power Option)
Power to Relays/SSR Outputs
2300 Vac per 1 min. test
Relays/SSR to Relay/SSR Outputs
2300 Vac per 1 min. test
RS-232/485 to Inputs/Outputs
500 Vac per 1 min. test
(no isolation is provided for Strain units)