Omega CNiS8DV - Manual (Page 34)

3.2.8 Analog Output (Retransmission) Menu
Analog Output can be configured as Retransmission or Control outputs.
In this section we will discuss Retransmission Output.
This unit is equipped with two physical outputs that can only be configured as
follows: Alarm 1 & Alarm 2, Alarm 1 & Output 2, Output 1 & Alarm 2, Output
1 & Output 2, Analog Out 1 & Alarm 2, Analog Out 1 & Output 2. Analog
Output is available only if Analog Output Option board is factory installed.
If Analog Output Option is not installed, the instrument will skip to Alarm 2 Menu.
Figure 3.6 Flow Chart for Analog Output (Retransmission) Menu
ENTER ANALOG OUTPUT MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until display advances to ANLG Analog
Output Menu.
Press d 4) Display advances to Analog Output ENBL Enable or DSBL
Disable Submenu and flashes the previous selection.
30