Onkyo CDR-205X - Manual (Page 26)

26
Digital recording
AUDIO CD RECORDER
ON / OFF
STANDBY
CDR-205X
CD DUBBING
DISPLAY PUSH TO ENTER ( )
AMCS
REC
FINALIZE
INPUT
EDIT/NO
YES
DUAL OPTICAL INPUT
POWER
TION OPERA
RANDOM
MEMORY
T REPEA
REC
1 2 3
4 5 6
7 8 9
10 / 0 >10
SKIP ID
CLEAR
CLEAR SET DISPLAY SKIP PLAY
CLOCK SLEEP EFFECT G.EQUALIZER
TUNER
MODE POWER
FM AM INPUT PRESET
TAPE
DVD PAUSE/STEP
MD
CD
SCROLL REPEAT
CLEAR PLAY MODE
RANDOM REPEAT
REC
CLEAR DISC MEMORY
CDR REPEAT
TIMER
UP/DOWN
ENTER
CLEAR REC
PLAY MODE
TONE
1 2 3
4 5 6
7 8 9
- - / - - - 10/0
MUTING
VOLUME
PRESENCE
OFF 1 2 3
ACOUSTIC
REMOTE CONTROLLER RC-414S by
RC-413C
INPUT
REC o
o REC
s
s
REC o
EDIT/NO n
YES q AMCS w
RC-414S
2
Adjust the recording level
(see page 29)
3
Press the o REC button (or the remote
controller REC o button).
"Rec setup" appars in the display followed by
the time display (the recording standby state).
Note:
Verify to which digital input the optical digital
cable is connected. If you select the digital input
to which the cable is not connected, "D.In
Unlock" will appear.
Perform digital recording to record the signal input
to the optical digital input terminal of the CDR-
205X. The track numbers are recorded as is from the
input source. The recording level can be adjusted
manually.
Types of digital source that can be recorded
The CDR-205X contains an internal sampling rate
converter, and therefore can record digital signals of
the sampling rates given below.
• 44.1 kHz (CDs, etc.)
• 32 kHz (DAT, satellite broadcasts, etc.)
• 48 kHz (DAT, satellite broadcasts, etc.)
Note:
When performing a digital recording from HDCDs,
DTS CDs, and the like, be sure to set the recording
level to 0 dB (see page 29). Since the recording level
is set automatically (DLA) when dubbing a disc using
the CD DUBBING button, recording cannot be
performed.
Preparation
• Turn on the CDR-205X (see page 15).
• Place a recordable CD-R or CD-RW in the CDR-
205X (see page 16).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
1
Repeatedly press the INPUT button
until "Digital In1" or "Digital In2"
appears.
REC
REC
REC
CDR-205X RC-413C RC-414S
4
Press the n button (or the remote
controller s button) and start the
recording source.
Recording starts. The track numbers are
automatically recorded as well. If the entire disc
becomes filled with recordings, the CDR-205X
automatically stops.
To pause the recording
Press the n button (or the remote controller g
button). To resume recording, press the n button
(or the remote controller s button).
To stop the recording
Press the e button.
Notes:
• When digitally recording satellite broadcasts, the
track numbers may not be assigned properly. If
this occurs, turn off the level sync function and
set the track numbers manually.
• If the time between tracks is extremely short, the
track numbers may not be assigned properly.
INPUT
or