Onkyo CDR-205X - Manual (Page 42)

42
If the CDR-205X begins to operate improperly, use the troubleshooting guide below to help you ascertain the
problem.
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to
external noise or static electricity. If this happens, disconnect the power cord and then plug it in again after
about 5 seconds.
About the self-diagnosis function
The CDR-205X is equipped with a self-diagnosis function. If a malfunction is detected during operation, one
of the messages given below will appear in the front display.
Display Cause Remedy
Disc Error • Playback was likely stopped due to dirt, • Eject the disc and check for dirt, dust,
dust, scratches, or vibrations. and scratches (see page 16).
• The disc has been placed in • Eject the disc and check that it is placed
upside down. in correctly (see page 16).
If you place the disc correctly and the
same message appears, unplug the power
cord and plug it back in again. If the same
message appears again, contact an Onkyo
service representative.
Sys. Error A malfunction has occurred in the system Unplug the power cord and plug it back
(flashing) due to excessive noise or static electricity. in again. If the same message appears
again, contact an Onkyo service
representative.
Troubleshooting guide
Messages during recording
Display Cause Remedy
Cannot Copy The input digital signal contains Record an analog signal or recordable
a copy guard signal (SCMS). music signal (see page 48).
Cannot Rec • The digital input is blocked. • Verify that the player component is
properly playing and the digital cable is
properly connected. (see page 12).
• Data has been input in the • Verify that source signal is a normal
CD-ROM, etc. music signal (see page 18).
Check Input The player component was already Stop the player component. Shortly thereafter,
↓ ↑
playing. "Signal Wait" will appear (see page 28).
Rec Setup
Rec Setup The CDR-205X is entering the Wait until the message disappears.
recording standby state.