Onkyo CDR-205X - Manual (Page 43)

43
Other Information
Troubleshooting guide
Messages during recording (continued)
Display Cause Remedy
Repair After recording, the disc was left in While “Repair” is displayed, the
the CDR-205X when the power was CDR-205X is tracing back through the
turned off and the track numbers and recorded area and repairing the track
recording time data was lost. numbers and recording time data.
When the message disappears,
finalization of the disc is possible.
Depending on the recording amount,
this process may take up to 40
minutes.recording time data was lost.
Disc Full Either the disc is full of recordings or Use a new disc.
99 tracks have been recorded and no
more recordings can be made on the disc.
Pro Disc A CD-R not for music recording use Eject the disc and check whether it meets
(without the "FOR CONSUMER" marking) the specifications for use with the
or a CD-RW has been inserted. CDR-205X. Always insert a disc that has .
the markings "FOR CONSUMER" or "FOR
MUSIC USE ONLY" on its surface
(see page 10).
Messages during playback
Display Cause Remedy
Blank Disc You have tried to play a disc that has If the inserted disc is a CD-R or CD-RW
no recordings on it. with no recordings, you may record onto it,
but it cannot be played.
No Disc No disc has been inserted. Open the disc tray and make sure that a
disc is inserted (see page 16).
Now Setting The CDR-205X is warming up. Please wait.
Recovering This is displayed after the power has been Wait until the message disappears
or if the power is accidentally turned off (see page 18).
during a recording, the CDR-205X will enter
this mode to repair the disc for additional
recordings.
Over You reached the end of the disc
by pressing the search button during
playback or while the CDR-205X was paused.