Onkyo CDR-205X - Manual (Page 28)

28
Synchronous recording by input digital signal
detection
AUDIO CD RECORDER
ON / OFF
STANDBY
CDR-205X
CD DUBBING
DISPLAY PUSH TO ENTER ( )
AMCS
REC
FINALIZE
INPUT
EDIT/NO
YES
DUAL OPTICAL INPUT
POWER
TION OPERA
RANDOM
MEMORY
T REPEA
REC
1 2 3
4 5 6
7 8 9
10 / 0 >10
SKIP ID
CLEAR
CLEAR SET DISPLAY SKIP PLAY
CLOCK SLEEP EFFECT G.EQUALIZER
TUNER
MODE POWER
FM AM INPUT PRESET
TAPE
DVD PAUSE/STEP
MD
CD
SCROLL REPEAT
CLEAR PLAY MODE
RANDOM REPEAT
REC
CLEAR DISC MEMORY
CDR REPEAT
TIMER
UP/DOWN
ENTER
CLEAR REC
PLAY MODE
TONE
1 2 3
4 5 6
7 8 9
- - / - - - 10/0
MUTING
VOLUME
PRESENCE
OFF 1 2 3
ACOUSTIC
REMOTE CONTROLLER RC-414S by
RC-413C
INPUT
REC o
REC o
o REC
RC-414S
REC
REC
REC
CDR-205X RC-413C RC-414S
INPUT
Notes:
• If "Check Input" and "Rec Setup" flash
alternately and recording does not start, then the
recording source was likely already playing and
not allowing recording to start. First stop the
recording source and then resume operations.
• CD DUBBING uses a sub-code signal that is
contained in the digital output from most player
components, and therefore there may be some
CD players, MD recorders, or the like where
digital synchronous recording is impossible.
5
Verify that "Signal Wait" is flashing in
the display and then start the playback
of the recording source.
Recording starts as soon as the unit receives
signals from the recording source.
Level Sync automatically set to On.
4
Press the o REC button (or the remote
controller REC o button)
The CDR-205X enters the input standby state,
"Signal Rec" appears in the display, and then
"Signal Wait" appears flashing.
2
Adjust the recording level
(see page 29)
3
Press the o REC button (or the remote
controller REC o button)
“Rec Setup” appears in the display followed by
the time display.
When recording with portable MD players, or other
components that are not equipped with an z
connector, recording is started synchronous with the
input signal. (This is called digital signal synchronous
recording.)
Preparation
• Turn on the CDR-205X (see page 15).
• Place a recordable CD-R or CD-RW in the CDR-
205X (see page 16).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
1
Repeatedly press the INPUT button and
select the desired input signal.
Select "Digital In1" either "Digital In2" for the
input source.