Over And Back 180 - Manual (Page 175)

Chapter 7 Page 175
7. Tap the Speed pick list and select 57,600.
8. Tap the Country pick list and select the country in which you are using your communicator.
9. Tap the Flow Control (Flow Ctl) pick list, and select Automatic, On (Xon), or Off (Xoff) flow
control for the modem connection.
10. If needed, edit the Init String to change the modem setup string.
11. Hold Option and press Return twice to return to the Connection Preferences screen.
The following steps demonstrate how to create a modem connection that enables IR HotSync
through an IR enabled modem. This modem would then dial a modem attached to your desktop
to perform the remote HotSync operation.
To create an IrCOMM to Modem connection:
1. In the Connection Preferences screen, tap New.
2. Enter a name for this configuration.
3. Tap the Connection Method pick list and select IrCOMM to Modem.
4. Tap the Dialing pick list and select TouchTone or Rotary.
Note: Select Rotary only if your telephone service does not support TouchTone dialing.
5. Tap the Volume pick list and select the speaker volume.
6. Tap Details.