Over And Back 180 - Manual (Page 201)

Chapter 8 Page 201
Preparing your computer
There are a few steps you must perform to prepare your computer for a wireless HotSync
operation. Be sure to perform these steps before you leave your office so that your computer is
ready to receive a call from your communicator.
To prepare your computer for a wireless HotSync operation:
1. Confirm that the computer modem is connected and turned on, and that no communications
applications, such as fax or telephony software, are running on a COM port.
Note: Make sure the computer is disconnected from all online services, such as America
Online (AOL) and CompuServe. This helps to avoid conflicts with the COM port.
2. Start HotSync Manager if it is not already running, and from the HotSync Manager menu,
choose Modem.
3. Adjust the following options as needed.
4. Click OK.
Serial Port Identifies the port for the modem. If you are unsure of the port assignment,
look at the Modem Properties in the Windows Control Panel.
Speed Determines the speed at which data is transferred. Try the As Fast As
Possible rate first, and adjust downward if you experience problems. This
setting allows your desktop software and your communicator to find and
use the fastest speed.
Modem Identifies the modem type or manufacturer. Refer to your modem manual
or face plate for its type or settings. If you’re not sure of your modem type
or your modem doesn’t match any that appear in the list, select Hayes
Basic.
Setup String Identifies the setup string for your particular modem. Not all modems
require a setup string. Refer to your modem manual and enter the setup
string if recommended by the manufacturer.