Over And Back 180 - Manual (Page 220)

Page 220 Troubleshooting Tips
HotSync problems
Problem Solution
Why can’t I synchronize
my communicator with
my computer? Try each of these in turn. After each step, try to synchronize to see
if the problem persists:
■ Make sure you installed the software that came with your
communicator. You must install this software even if you
upgraded from another Palm OS handheld.
■ Make sure there are no active calls on your Treo before you
begin a HotSync operation. You cannot synchronize while you
have an active call, and you cannot make or receive calls during
a HotSync operation.
■ Make sure you selected your user name in Palm Desktop
software before beginning the HotSync operation.
■ Perform a soft reset. See page 210 for details.
■ Make sure the HotSync Manager icon

appears in the
Windows system tray in the lower-right corner of the screen. If
it does not appear, open the Start menu, select Programs,
Handspring, and then HotSync Manager.
■ Click the HotSync Manager icon and make sure that the Local
USB option has a check next to it. If you are using an optional
serial cable, make sure that the Local Serial has a check next
to it, then select Setup and confirm that the COM port setting
matches the port where you attached the serial cable.
■ Make sure the cable is connected securely to your computer
and your communicator.
■ Make sure you are using the correct type of cable. If your
computer does not have a USB port, or is running Windows 95
or Windows NT 4.0, you must use a serial cable.
■ If you’re using a USB cable, insert the Handspring CD into your
computer, use Windows Explorer or My Computer to navigate
to the Utilities folder, and then run the Visor USB registry utility.
■ If you are using a USB cable, disconnect any other USB devices
you are using. If you’re connecting your cable to a USB hub,
disconnect it and connect your cable directly to your computer.
■ If you are using a serial cable, try a lower baud rate setting on
the Local tab in the Setup dialog box.
■ Restart your computer.
■ If you installed a conduit from a third-party software developer,
contact the developer for support.