Onkyo TX-SR8360 - Manual (Page 40)

40
First Time Setup —Continued
■ How to Verify the Measurement Results
By selecting “Check the Results” at step 4, you can dis-
play the following screen to confirm the measurement
results.
3 Press [ENTER].
The automatic speaker setup starts.
The test tone is output by each speaker
in turn, measured by the microphone,
and the speaker settings set accordingly.
The whole process takes about 2 minutes.
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so be careful.
4 Once the measurement is com-
pleted, the following completion
screen appears.
Use the Up and Down [ ]/[ ]
buttons to select any of the fol-
lowing options, and then press
[ENTER].
Apply the Results:
Validates the measurement results and
closes the screen. Normally you may
want to select this option. Continue
with step 5.
Check the Results:
Displays the measurement results for
your reference. Continue with “How to
Verify the Measurement Results”
described below.
Retry:
Retries measurement. Return to step 2.
Retry with Test noise Level up:
Retries measurement with the test
sound at high volume level. Return to
step 2.
Cancel:
Closes the screen without validating
the measurement results. Continue with
step 5.
ENTER
ENTER
ENTER
5 Disconnect the speaker setup
microphone.
To cancel the automatic setup while it’s
in progress, disconnect the micro-
phone.
Use the Up and Down [ ]/[ ]
buttons to select the item that
you want to check, and then
press [ENTER].
Press the [RETURN] button to return to
the previous display.
ENTER
ENTER
1 Warning
2 Number of speakers and their sizes
3 Distance from each speaker to the
listening position
4 The optimum volume level for each
speaker
5 The level adjustment for individual
frequency range covered by
respective speaker