First time setup —continued – Onkyo TX-SR8360 User Manual
Page 51
51
First Time Setup
—Continued
Equalizer Setting
Here you can adjust the EQ of individual speakers. To set
the volume of individual speakers see page 50.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
]/[
]
buttons to select “5. Equalizer
Settings,” and then press
[ENTER].
The Equalizer Settings menu appears.
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
1, 7
2–6
2
1
RECEIVER
ENTER
ENTER
3
Use the Left and Right [
]/[
]
buttons to select:
Off:
Tone off, response flat.
Auto:
The tone for each speaker is
set automatically by the
Automatic Speaker Setup
function.
Manual:
You can adjust the EQ of each
speaker manually.
If you select Manual, continue with this
procedure. If you select Off or Auto, go
to step 7.
4
Use the Down [
] button to
select “Channel,” and then use
the Left and Right [
]/[
] but-
tons to select a speaker.
5
Use the Up and Down [
]/[
]
buttons to select a frequency,
and then use the Left and Right
[
]/[
] buttons to adjust the
level at that frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip:
Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8 kHz) affect treble sounds.
6
Use the Up [
] button to select
“Channel,” and then use the Left
and Right [
]/[
] buttons to
select another speaker.
Repeat steps 5 and 6 for each speaker.
7
Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
ENTER
ENTER