Onkyo TX-SR8360 - Manual (Page 48)

48
First Time Setup —Continued
Crossover
Note:
If the crossover frequency is set to a low value, and the
program material doesn’t contain any sounds below that
frequency, the subwoofer will not output much sound.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can be set only
if the Subwoofer setting in step 3 is set to Yes, and the
Front setting in step 4 is set to Large.
In the speaker setup screen, you can choose how bass
information is distributed to your speakers only if you
have large front left and right speakers AND a sub-
woofer.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
9 Use the Up and Down [ ]/[ ]
buttons to select “g. Crossover,”
and then use the Left and Right
[
]/[ ] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
Continue with step 10 in the right col-
umn.
ENTER
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
60 Hz
6-1/2 to 8 in.
(16–20 cm)
80 Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100 Hz
3-1/2 to 5-1/4 in.
(9–13 cm)
120 Hz
Under 3-1/2 in.
(9 cm)
150 Hz
10 Use the Up and Down [ ]/[ ]
buttons to select “h. Double
Bass,” and then use the Left and
Right [
]/[ ] buttons to select:
On: Double Bass function on
(default). Front left and right
bass also goes to the sub-
woofer simultaneously.
Off: Double Bass function off.
11 Press the [SETUP] button.
The setup menu closes.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 39).
ENTER