Ositech comm Trumpcard Data/Fax Modem - Manual (Page 36)

4 - 4 Trumpcard 14400/28800 Modem
Section Four
Modem Command Summary
Command Title Default
A/ Re-execute Command none
A Answer none
Bn Set ITU-T or Bell Mode 1 *
Dn Dial T
En Command Echo 1 *
Fn Select Line Modulation (14400) none
+MS Select Line Modulation (28800) none
Hn Switch-Hook Control none
In Identification none
Ln Speaker Volume 2 *
Mn Speaker Control 1 *
Nn Automode Detection 1 *
On Return To The On-Line State none
P Set Pulse Dial As Default none *
Qn Result Code Display 0 *
Sn Reading/Writing S Registers none
T Set Tone Dial As Default none *
Vn Result Code Form (Message Control) 1 *
Wn Connect Message Control 0 *
Xn Extended Result Codes 4 *
Yn Control Long Space Disconnect 0 *
Zn Reset none
&Cn DCD Option 0 *
&Dn DTR Option 0 *
&F Restore Factory Configuration none
&Gn Set Guard Tone 0 *
&Jn Telephone Jack Selection 0 *
&Kn DTE/Modem Flow Control 3 *
&Ln Line Type 0 *
* Indicates command is saved in Non-Volatile Memory