Ositech comm Trumpcard Data/Fax Modem - Manual (Page 38)

4 - 6 Trumpcard 14400/28800 Modem
Section Four
Modem Command Descriptions
A/ — Re-execute
Parameters none
Default none
Re-executes the most recent AT command string. The principle
application of this command is to place another call (e.g., Dial command)
that failed, to connect due to a busy line, no answer, or a wrong number.
This command must appear alone on a command line and must be
terminated by the "/" character. (An [ENTER] should not be entered to
terminate the command.)
A — Answer
Parameters none
Default none
This must be the last command entered into the command line. The
modem proceeds with the connect sequence in answer mode. The
modem will enter the connected state after exchanging carrier with the
remote modem. If no carrier is detected within a wait period specified in
register S7 (default = 30 seconds), the modem will disconnect. Any
further characters entered during the connect sequence will abort the
command.
Result Codes
CONNECT XXXX If a connection is established (XXXX = telco line
speed, e.g. 2400)
NO CARRIER If a connection cannot be established, the abort
timer (register S7) expires, or if the command is
aborted